Note and automation editing in the Inspector In the Inspector you can edit note and automation events numerically using the displays. Editing notes and events in the Inspector If you select a note, four displays appear in the Inspector, showing the event (start) Position, Length, Note number and Velocity value: If you select a parameter automation event, two displays appear, showing the event’s Position and Value: If you select a pattern automation clip, three displays appear, showing the clip’s Position, Length and Pattern Offset: Edit the values by clicking on a segment in a display and then drag up/down, use the up/down spin controls, or type in new values. Snap is not taken into account. See “Inspector segment displays” for details on how to edit in the Inspector displays. Note that when moving the position of events, these may end up outside the clip and be masked (not played). There will be no warning or indication if this should happen. However, since the clip is open in Edit Mode, you will be able to see if events are masked. • If the Tick segment in the Position and/or Length displays shows an asterisk (*), it means that the value is a fraction of a Tick - a subtick. See “About subticks in the Position and Length displays” for more info. Editing values for multiple notes or events in the Inspector When you edit values for several selected events, the changes will always be relative. For example, if you change the position, length, pitch or velocity when several notes are selected, they will all be changed by the same amount, retaining their relative values. • If several events are selected, the displays will show the values for the event with the earliest start position in the song. If several selected events have the same start position, the displays will show the values for the event with the lowest Note value (for note events) or lowest Value (for automation events). • If several events are selected and any of their values differ, Match Value buttons appear next to the corresponding display. See “Matching notes or events using the “Match Values” function”. Matching notes or events using the “Match Values” function The Match Values buttons appear as ‘=’ signs. The “Match Values” function in the Inspector can be used for matching the positions, lengths and velocities of several selected note events to the position/length/velocity of the selected event with the earliest start position in the song. It’s always the values of the earliest event that are shown in the displays. Similarly, automation events can be matched to the position and/or value of the earliest selected automation event in the song. If several selected events have the same start position, the matching will be to the values for the event with the lowest Note value (for note events) or lowest Value (for automation events). Matching notes Here’s an example on how to match note values: 1. In Edit Mode, select several notes. Four selected notes in Edit Mode. 2. Click the respective Match Values button to achieve the following results: Matching parameter automation events Matching parameter automation event values is useful if you want an automated device parameter to be modulated to the same value throughout the clip. • Let’s say you want to modulate a parameter to a maximum value of 80 several times throughout the clip. Then, just select all “max value” events, click the “Match Values” button and then adjust the Value to 80 for the selected events. Matching automation events positions can be useful under the following circumstances: • If you want to match the positions of single performance controller events on several Performance Controller Automation lanes. • If you want to match the position of two adjacent automation events in a clip to create an instant “jump” between the two values. Matching the positions of several automation events in a single clip is not really useful. It will only place them in a “pile” on the same position. The effect during playback would be an instant jump between the extreme values. In practice, all events in between the extreme values will be disregarded.
