The EQ section

The equalizer in RV7000 Mk II affects the wet reverb sound only and is used for shaping the character of the reverb. There are two EQ bands, one for low frequencies (shelving) and one full-range parametric EQ.

To activate the EQ, click the EQ Enable button on the main panel so that the indicator lights up.

To make EQ settings, select “EQ” with the Edit Mode button to the left in the remote programmer panel.

In this mode, the remote programmer display shows a frequency curve, indicating the settings you make with the EQ parameters.

The parameters are:

| Parameter	| Description
Low Gain	The amount of cut or boost of the low-shelving filter.
Low Freq	The frequency below which the Low Gain cut or boost is applied.
Param Gain	The amount of cut or boost for the parametric EQ.
Param Freq	The center frequency of the parametric EQ, e.g. at which frequency the level should be decreased or increased.
Param Q	This governs the width of the affected area around the set center frequency. The higher the value, the narrower the affected frequency range.

Remember that you have a third EQ band at your disposal - the HI EQ parameter on the main panel.

The reason why this is on the main panel and not in the EQ section is simply that it’s a setting you may want to adjust often, without having to open the remote programmer panel.